Aquatech Information
Eyeline Goggle Information
UV Protection
 |
Every Eyeline goggle has added ultra-violet protection as a standard feature. Designed for the outdoor swimmer to provide essential protection from sunlight & ultra-violet light. |
Anti-Fog
 |
Eyeline anti-fog models are treated using the most advanced coatings available today. Anti-fog lenses provide excellent optical clarity for all swimming conditions. Note: Anti-fog inner lens coatings should never be rubbed or scratched as this will render the treatment ineffective. Do not use anything to clean inner surfaces that will scratch the surface. Rinse goggles in fresh water after every use and airdry. From time to time it is suggested to use the Eyeline anti-fog spray to keep your goggles clean and to reduce ‘fi lm build-up’ on the inner surface which will lessen the effectiveness of the anti-fog treatment and also reduce the optical clarity of your swim goggles. |
Goggle Seals
 |
Foam: High quality foam ensures comfort and protection for the face. |
 |
TPR: New generation Thermo Plastic Rubber is a pliable material. It provides a comfortable soft seal and leak resistant properties. |
 |
Silicone: The ultimate comfort. 100% silicone seals provide the highest leak resistant properties. |
 |
No Seal: The Original 'No Seal' Racing Goggle. Top quality engineering allows this model to be worn without a conventional seal whilst still affording excellent seal properties. For the more experienced swimmer. |
Headbands
 |
Rubber: A soft elastic material for general swimming use. |
|
 |
TPR: A high quality pliable strap material with soft fi nish and durability. |
|
 |
Silicone: A high quality strap providing extra strength and durability. |
|
Fitting Instructions
Adjust the headband (see following page) by releasing the tension through the clip lock buckle, slide through buckle to the correct length. Clip headband into correct buckle position to prevent releasing whilst swimming. Carefully position lenses over the eyes with the nose piece in the upright position facing away from your face, slide the headband (which you have adjusted to the correct length) over your head. Position headband correctly. To remove, slide headband back over your head.
DO NOT attempt to adjust length of headband while it is clipped into the buckle unless you have released the tension as you will more than likely snap the headband close to the end. Before entering the pool it is suggested to dip goggles in the pool water and wet your face and hair, as this makes the goggle fi tting more comfortable, gives you a better seal and activates the anti-fog feature.
Care: Treat with care as the polycarbonate lenses may scratch. DO NOT WIPE OR TOUCH INSIDE THE LENSES as you may damage the anti-fog coating. Wash goggles in fresh water after each use and dry in the shade. DO NOT expose to excessive heat as this will damage your goggles. Use Eyeline anti-fog solution to clean your goggles, spray a small amount in each lens and dab with a soft cloth or tissue to remove excess spray.
Warning: As with anything near the eye, all care should be taken to prevent eye injuries. Children should only use goggles under competent supervision. If irritation or injury occurs, discontinue use immediately and consult a doctor. FOR SURFACE SWIMMING ONLY.
Correct Headband Usage
Eyeline headbands are designed to be ‘non-slip’ so it is essential to release the tension through the buckle before adjusting the length. Failing to release the tension through the buckle, the tighter you pull the headband the tighter it locks and you will exceed the natural length of any given section and snap the headband.
 |
Eyeline headbands are designed to be 'non-slip' so it essential to release the tension through the buckle before adjusting the length. Failing to release the tension through the buckle, the tighter you pull the headband the tighter it locks and will exceed the natural length of any given section and snap the headband. |
Correct Headband Usage for most other models except Plexus and Spectrum
 |
1. Twist straps through the buckle gap |
 |
2. Once buckle is unlocked adjust straps |
 |
3. Twist straps back into the lock position |
 |
|
 |
|
Correct Headband Usage for Plexus model
 |
1. Twist straps through the buckle gap |
 |
2. Once buckle is unlocked adjust straps |
 |
3. Twist straps back into the lock position |
 |
|
Correct Headband Usage for Spectrum/Spectrum Mirror models
 |
1. Twist straps through the buckle gap |
 |
2. Once buckle is unlocked adjust straps |
 |
3. Twist straps back into the lock position |
Buckle position  |
|
